The Breakroom > Resources

Building a Powdercoat Oven

<< < (2/2)

Brass_Machine:
Very cool indeed. What are you using for a gun? I have a very cheap one... the HF version. It does an OK job, but I am going to get the Eastwood to replace it.

Eric

PTsideshow:
At one point in time horrible fright and eastwoods were selling the guns. you may also want to check out caswell I put ta link to it they sell the powder coating stuff also.

Brass_Machine:

--- Quote from: PTsideshow on May 12, 2008, 01:57:20 PM ---At one point in time horrible fright and eastwoods were selling the guns. you may also want to check out caswell I put ta link to it they sell the powder coating stuff also.

--- End quote ---

I am familiar with the Caswell's site. Got a lot of good info and stuff there. I actually bought my gun off of ebay... same one that HF sells. A co worker got the cheap eastwood gun... it does a much better job than my HF gun. But since I am not doing any coating for retail... only small pieces it will do ok for awhile.

Eric

Brass_Machine:
This is my vice stop I built and coated:




Eric

PTsideshow:
It looks good. I will admit I haven't been on a motorcycle in close to 30 years but it still looks good.

Navigation

[0] Message Index

[*] Previous page