| The Shop > Our Shop |
| Who has the messyest shop/garage???? |
| << < (7/13) > >> |
| MrFluffy:
Theres a rover v8 engine halfway up the rubble that forms the staircase to be that leads to the upstairs storage here in the new place. I realized it couldn't be done on my own no matter how much I tried to pinchbar it up so sheeted it over till I get the jcb running properly again or my neighbor pops round with a telehandler for something else... Theyre not whole motorcycles, theyre just bits ready for mutating some poor unsuspecting one. The bikes themselves live somewhere else mostly although I somehow did manage to get my xt500 up the same rubble staircase before giving it up as a bad idea and putting them downstairs in one of the old milking parlors although the floor in there is a bit trecherous too having weird troughs and the remnants of the feed and watering troughs cast into it. Ive almost got used to smacking my head on that big oak beam which supports the underneath of the upper floor too. |
| Brass_Machine:
--- Quote from: BillTodd on November 07, 2010, 05:06:06 PM ---Ducati 851 Strada '89 monoposto --- End quote --- Doh! Should have known that. I had a 888 for awhile... |
| PTsideshow:
Well since there seems to be a lack of USA representation. Here are some shots of my shop's 1st floor. Looking to the left side from center Looking to the right side from center Looking to the rear wall from the front These three are the fall out from vinyl siding and aluminum trim on a 2 1/2 story house. 10'6" aluminum trim brake buried under stuff. A shot of that flat surface virus in a shop, No flat surface goes un cluttered for less then 24 hours. And finally a 17 pound ball of trimmings from cutting the aluminum coil stock to size for bending. Will get the the second floor tomorrow, along with the material storage outside and the one of the obligatory motorcycle :lol: |
| Artie:
--- Quote from: tumutbound on November 08, 2010, 07:59:32 AM ---The bike is a Rickman CB750 Honda. --- End quote --- $$$? Ive heard of a Rickman, in fact I know a fellow who is looking for a 750 Honda based Rickman..... RobT |
| tumutbound:
--- Quote from: Artie on November 08, 2010, 11:48:37 PM --- $$$? Ive heard of a Rickman, in fact I know a fellow who is looking for a 750 Honda based Rickman..... RobT --- End quote --- I'm not sure what they're worth these days so have tried to give it a $$$ value. They're pretty rare and this example is complete, if a little neglected. I'll ahve to see how it scrubs up. I've had this one since I imported it in the mid 70s from RGM Motorcycles in Luton. |
| Navigation |
| Message Index |
| Next page |
| Previous page |