Gallery, Projects and General > Gallery

A Stirling engine

(1/3) > >>

cidrontmg:
Another gamma Stirling. Both strokes are 15 mm, work piston is 12 mm dia graphite, displacer is 17.5 mm dia and the glass cylinder is 18.5 mm inside.


Another picture


This is what she drinks, no meths, straight stuff...


And here she runs


The flywheels have some balancing, but not enough, she walks around the table somewhat.
The burner tube is too long, the wick stands too high. Have to cut a bit off it, and fix it to a proper board. No polishing yet, just finished it yesterday so it would run. Always nice when a new machine behaves   :)
 :wave:

AdeV:

--- Quote from: cidrontmg on October 27, 2010, 06:54:38 AM ---
Another picture


This is what she drinks, no meths, straight stuff...



--- End quote ---

Beautiful work, that's a classy looking engine.

I hope to emigrate to Portugal in a couple of years time (approx), nice to know where I can get rubbing alcohol :)

Brass_Machine:
Self build? Pictures of the build process? did you follow plans?

Very nice!

Eric

Stilldrillin:
Cid.
That's beautiful!   :bugeye:

Runs so smoothly/ quietly too.   :clap:

Well done!  :thumbup:

David D

sbwhart:
Good Job A great runner

Stew

Navigation

[0] Message Index

[#] Next page