The Breakroom > Resources

Flywheels.....

<< < (3/3)

Rob.Wilson:

--- Quote from: Brass_Machine on October 20, 2010, 10:36:01 PM ---I think I read somewhere that some has used iron weights for a flywheel... hmmm. Have to see if I can remember where that is.

Eric

--- End quote ---

Here we go Eric  :thumbup: http://madmodder.net/index.php?topic=1570.msg15338#msg15338   CallMeAl use one for a flywheel on his engine   ,,, cool lookin engine too  :thumbup:


Rob

Stilldrillin:
That's it Rob!  :thumbup:

I had a feeling I'd seen something, somewhere, which used a weight. What a cracker it is, an all!  :clap:

Now, If I could adapt that, for a flamelicker.......  :scratch:

One day. Mebbe. Perhaps!  ::)

David D

crabsign69:
that was cool i liked that one  thanks for finding it and showing us.  :mmr:

Bogstandard:
I have shown these before, but for anyone in the UK (they would be a bit pricey to ship overseas) who just wants the odd flywheel at very low prices, Then RDG sell 3 different types. I have a few in stock, just in case.

http://rdgtools.co.uk/acatalog/Models_and_Steam_Fittings.html

Saves a lot of hard work trying to cut them out yourself.


Bogs

Rob.Wilson:
 :bugeye: CANNY cheap to John  :thumbup:


Rob

Navigation

[0] Message Index

[*] Previous page