| Gallery, Projects and General > How do I?? |
| Rotary Table - another dumb question... |
| << < (4/4) |
| techno ludite:
Hi All Just adding my 2p worth, when I was machining the pump, what I used to do was put a large diameter rod in the rotary table chuck, line it up with the drill chuck make sure both are nice and tight, and then bolt the table to the cross slide, once done tighten the clamps so not to lose the zero/zero setting. Then remove the rod. I don't know if this is going to work in your case or with your equipment. And one other thing make sure the machine is isolated otherwise your gonna get some expensive scrap lying around or a trip to A + E. TL |
| Navigation |
| Message Index |
| Previous page |