The Breakroom > The Water Cooler
Looking for someone who can weld aluminum
Brass_Machine:
I am looking for someone who can weld aluminum. I have some work that needs to be welded on my motorcycle frame. Someone in the E. PA/NJ/S.E. NY/DE/MD/CT area who can do strong clean aluminum welding?
Eric
Bernd:
Sounds like you need some one who knows how to TIG weld aluminum.
To bad your not closer to me. I know a guy that TIG's aluminum. It's the way to go, nice and clean looking weld.
Good luck Eric.
Bernd
rleete:
I know I guy that can do it, and do it well. Unfortunately, it's up near me, so probably out of your way.
Powder Keg:
I could do it. Oh wait, It has to be clean and strong..... Nevermind :poke:
Lew_Merrick_PE:
--- Quote from: Brass_Machine on August 25, 2010, 10:20:08 PM ---I am looking for someone who can weld aluminum. I have some work that needs to be welded on my motorcycle frame. Someone in the E. PA/NJ/S.E. NY/DE/MD/CT area who can do strong clean aluminum welding?
--- End quote ---
Eric, This has been sitting here a while. Just about any truck/trailer weld shop should be able to do the task. Out this way (the Soviet of Washington) such shops charge $35 to $50 per hour usually with a 1 hour minimum charge. Alternatively, ask your local industrial cutter grinder shop for information as to someone who can weld dies, jigs, and fixtures. Such people do not need to advertise (so they don't spend the $$$) as they are magician caliber welders. In western Washington State, there are seven such magician caliber welders distributed among some (about) 3 million general population. There rates are a bit higher ($120/hour for the local one I use for such work), but they can be less expensive in the long run.
Navigation
[0] Message Index
[#] Next page
Go to full version