| Gallery, Projects and General > Project Logs |
| Moteur oscillant double effect |
| << < (9/19) > >> |
| sbwhart:
On we go:- Four holes were drilled and tapped M3 in the base, the set up for this was the same as for the other end so no pics. Last job on the standard mill out the slot to take the fly wheel, first a 9.5mm hole was drilled through, then using a nice new 10mm end mill the extended part of the slot was mill in all the components:- like this The the slot was milled out all the way through as far as the 9.5mm hole:- like this Her they are six of the seven done, the Seventh I've put to one side to experiment with later. Stew |
| madjackghengis:
Hi Stew, that's a mighty interesting looking vise you've got there, it appears to have tapped holes for bolting parallels and the like onto it. Looks mighty handy for doing just what you show, holding a piece vertical, and acting as a stop at the same time, I might be able to add that to my milling vise. Nice looking set of standards, nice work on display. :thumbup: mad jack |
| sbwhart:
Thanks Jack I've started a thread about my Vice :D The next bits to make call for a fair bit of turning, the first part is the pipe coupling nothing complicated about the turning so didn't take any pics. To drill the clamp holes I made a little jig, this is it in use. This is it with the the parts. Next operation mill the flats I made some little plugs to fit in the holes so that I could sit them on top of the vice and bring the holes level. Then I sat the milled side on a parallel to mill the other. This sort of worked but I was not happy with it I've got another similar part to make so may think up another method. And here they are all done and how they fasten the pipe to the Standard. Stew |
| Bernd:
Nice work Stew. Ah, jigs and fixtures. They sure make short work for multiple parts don't they? Bernd |
| Stilldrillin:
--- Quote from: Bernd on August 26, 2010, 04:50:53 PM ---Nice work Stew. Ah, jigs and fixtures. They sure make short work for multiple parts don't they? Bernd --- End quote --- I had 34 years of working with 'em, daily, until retirement. Stew doesn't realise, just how much his reminders are upsetting me....... :) Very nice work, Stew! :thumbup: David D |
| Navigation |
| Message Index |
| Next page |
| Previous page |