The Breakroom > The Water Cooler
Thanks to a fellow Madmodder
Brass_Machine:
Thanks for the mention Bob!
Haven't been to your blog in awhile... spent some good time there today.
--- Quote ---Well stop swanning round the country drinking tea with three sugars in and get your finger out.
--- End quote ---
Bahaha :lol: :lol: :lol:
Don't worry Rob... I gotta work on mine too!
Eric
BobWarfield:
Guys, you are entirely too kind.
I wanted to give a call out to MadModder on CNCCookbook, because there are so many great machinists and projects to be seen here!
:mmr:
Online boards are a lot like neighborhoods--they're made by their residents. This neighborhood has such a great vibe I hope all interested machinists get a chance to see it and participate.
Best Regards,
Bob Warfield
Rob.Wilson:
--- Quote from: Brass_Machine on June 30, 2010, 08:25:19 PM ---Thanks for the mention Bob!
Haven't been to your blog in awhile... spent some good time there today.
--- Quote ---Well stop swanning round the country drinking tea with three sugars in and get your finger out.
--- End quote ---
Bahaha :lol: :lol: :lol:
Don't worry Rob... I gotta work on mine too!
Eric
--- End quote ---
Hi Eric ,,,,,,, my mill works ,,,,,,,,,,,just i cant work it :bang: :lol: :lol: :lol: will have a cup of tea and think about it :coffee:
Anyone wanting a cool bit of software should take a look at Bob's GWizard ,,,,,,,,,,,,, downloaded it yesterday and used it today to get the position of the timing gear shaft on the casting ,,,,,,, a must for any shop :bow: :clap: :bow: :clap: :bow: :clap: :dremel: Thanks Bob
Rob
John Stevenson:
Except it needs this crap Adobe software to run.
No way is that shït going on my machine.
John S.
Rob.Wilson:
--- Quote from: John Stevenson on July 01, 2010, 04:32:08 PM ---Except it needs this crap Adobe software to run.
No way is that shït going on my machine.
John S.
--- End quote ---
And whats wrong with Adobe John ? :scratch:
Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version