| Gallery, Projects and General > Project Logs |
| Two cylinder steam engine with maudslay control |
| << < (2/3) > >> |
| Brass_Machine:
Nice work. I agree with the crispness of it. Very nice! Eric |
| stefang:
Thank you for the kind words, that motivates really :beer: As soon, as there are new parts finished, I will show them..maybe also a few pictures of the machine, showing how parts were chucked up or machined. Today I turned the lower conrod bearings: What? Four of them? ... I think, they should be milled down a bit: The result, splitted bearings: Mounted in the conrods: Good enough for me.. ::) Stefan |
| doubleboost:
Really nice :clap: :clap: :clap: Be good to se how they were machines Regards John |
| Stilldrillin:
Top notch work, Stefan! :clap: :clap: Well shown too! :thumbup: David D |
| stefang:
Here we go...the reversal control: Milling the bearing blocks from hot rolled mild steel: Milling the contour and roughing the holes: Aligning both bearing blocks on the conventional milling machine to bore them out: Boring job... ::) Drilling and boring a piece of flat, cold rolled steel for the levers: They will be cut in single pieces after that Back on the cnc machine, the jig to hold the levers: Alignment happens by the big bushing and the small 3mm pin, the part is held by the M5 screw Finished lever: The bearing blocks with the levers and bushings: Stefan |
| Navigation |
| Message Index |
| Next page |
| Previous page |