| Gallery, Projects and General > Gallery |
| Extra quick change tool holders for my A2Z QCTP |
| << < (2/7) > >> |
| swhite:
Dean, I guess what your saying is 3 halfs make a whole... :lol: |
| wongster:
Hi Steve, Are you able to share with me the dimension of the dovetail end? My measurements seem inconsistent each time. Regards, Wong |
| swhite:
Hi Wong, I used a 60 degree dove tail, the slot is 21mm wide, 4.84mm deep and the dove tail is 25.65mm from edge to edge when it is cut into the aluminum. I hope this helps you. Steve |
| wongster:
Thanks Steve. These are my measurements using the caliper: Height: 5.22mm Width of dovetail: 26.64mm The slot: 21.06mm What size dovetail cutter would you recommend? I've a 60 degree 1" wide. Seem a little big for this I think. Regards, Wong --- Quote from: swhite on June 27, 2010, 12:14:17 AM ---Hi Wong, I used a 60 degree dove tail, the slot is 21mm wide, 4.84mm deep and the dove tail is 25.65mm from edge to edge when it is cut into the aluminum. I hope this helps you. Steve --- End quote --- |
| swhite:
The dovetail cutter is a 3/4" 60 What material are you making your tool holders out of? Steve |
| Navigation |
| Message Index |
| Next page |
| Previous page |