| Gallery, Projects and General > Project Logs |
| Swarf production is in full swing. |
| << < (2/5) > >> |
| techno ludite:
No machining tonight just didn't feel like it, carp day at ( profanity alert ) work :whip:. The use of the sticky pin was shown to the apprentices on our first year training course away from our companies. by the milling section instructor. What you do is put a dress makers needle in some 'plasticine' pointy end out, stick it on the end of what evers in the chuck, spin it up, touch on on your work piece till the needle point stops wobbling about and there you have it, centre of the cutter over the edge of the job, move the workpiece to the required dimensions and as we say 'bobs ur uncle' an 'fannys ur aunt'. If that lot makes any sense, then i've explained it better than I thunk I did. TL |
| Stilldrillin:
Cough, cough....... :wave: http://madmodder.net/index.php?topic=1116.0 Think we`ve blinded `em with science TL..... ::) Nice little bits an bobs, you`ve made..... :thumbup: David D |
| shoey51:
Im watching this :thumbup: |
| techno ludite:
Hi All Bin busy this morning. I'm a great believer of a picture telling more than I can put down into words, so sorry if the write-ups are lacking. Form tool ground up correctly. Milling the wings. Finished milling Valve in-stu in the union to see if it fits. 1st off. Its there somewhere Ah there it is. And the rest are on my flickr page. TTFN TL :D |
| techno ludite:
Hi All Been a slow month so far what with losing my mojo :scratch:, then getting back at the weekend :med: . So here are the latest updates on the pump so far. Machining the back face of the valve plate. Finished machining. Shuttle valves part finished. Trial fit of the shuttle valves. Gasket clamped between valve plate and body. Gonna try and get some more done this weekend so keep looking. TL :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |