Gallery, Projects and General > Project Logs
R.W Gas Engine
Artie:
Excellent work! Truly inspiring mate.... casting rock! :beer: :headbang: :)
On to the next bit...
:poke:
NickG:
Brilliant! :clap:
Rob.Wilson:
Many thanks LADS for all your comments :beer: :nrocks:
Hi Eric ,, the risers are the two thick ,round things that are close to the mould , and work just as Ralph described :thumbup:
Not allot done , cut the gates of and a bit of a clean up of the casting
Stuck it on the 6X26 mill for size
Just need to fined away to hold it wile i mill the bottom flat ,,,,,,,, oh and finish wiring the mill ::)
Cheers Rob :thumbup:
John Stevenson:
--- Quote from: Rob.Wilson on June 16, 2010, 02:37:17 PM ---
Just need to fined away to hold it wile i mill the bottom flat
Cheers Rob :thumbup:
--- End quote ---
Bluetak ??
John S
Rob.Wilson:
--- Quote from: John Stevenson on June 16, 2010, 03:17:50 PM ---
--- Quote from: Rob.Wilson on June 16, 2010, 02:37:17 PM ---
Just need to fined away to hold it wile i mill the bottom flat
Cheers Rob :thumbup:
--- End quote ---
Bluetak ??
John S
--- End quote ---
Do you reckon one packet would do , or just a bit on each corner :scratch:
Cheers Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version