Gallery, Projects and General > Project Logs

R.W Gas Engine

<< < (21/26) > >>

Rob.Wilson:
Hi Lads  :wave:

Mulled a few ideas around for holding the casting to the mill , from blue tack to making a large vice with separate jaws that bolt to the mill table (future project ) any way had a brain fart and ended up poking a couple of holes in the casting ,so i could have something to grip.Them i welded a short lenght of 3/8 bar to a couple of clamps



The casting was then shimmed up on the mill and clamped down


Then off we go

job done


First job on the 626 mill ,, works well  :D

Cheers Rob


 

Stilldrillin:
Neat thinking Rob!  :thumbup:

David D

John Stevenson:
WELDED

Good heavens man, I'd have expected some custom clamp with a mirror finish and ground to 3 nano microns of the clamps life.

What is the world coming to ? welded ??

John S.

Stilldrillin:
Actually, John........

You`re right!      :lol: :lol: :lol:

David D  :thumbup:

Rob.Wilson:

--- Quote from: Stilldrillin on June 23, 2010, 04:41:32 AM ---Actually, John........

You`re right!      :lol: :lol: :lol:

David D  :thumbup:

--- End quote ---

Stop egging him on  :lol: :lol: :lol: :lol: :lol: :lol: :lol:

Rob  :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page