| Gallery, Projects and General > Project Logs |
| R.W Gas Engine |
| << < (21/26) > >> |
| Rob.Wilson:
Hi Lads :wave: Mulled a few ideas around for holding the casting to the mill , from blue tack to making a large vice with separate jaws that bolt to the mill table (future project ) any way had a brain fart and ended up poking a couple of holes in the casting ,so i could have something to grip.Them i welded a short lenght of 3/8 bar to a couple of clamps The casting was then shimmed up on the mill and clamped down Then off we go job done First job on the 626 mill ,, works well :D Cheers Rob |
| Stilldrillin:
Neat thinking Rob! :thumbup: David D |
| John Stevenson:
WELDED Good heavens man, I'd have expected some custom clamp with a mirror finish and ground to 3 nano microns of the clamps life. What is the world coming to ? welded ?? John S. |
| Stilldrillin:
Actually, John........ You`re right! :lol: :lol: :lol: David D :thumbup: |
| Rob.Wilson:
--- Quote from: Stilldrillin on June 23, 2010, 04:41:32 AM ---Actually, John........ You`re right! :lol: :lol: :lol: David D :thumbup: --- End quote --- Stop egging him on :lol: :lol: :lol: :lol: :lol: :lol: :lol: Rob :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |