Gallery, Projects and General > Project Logs
Heinrici type stirling
Rob.Wilson:
Hi Dean :bow: :bow: :bow: :bow: :bow:
WOW ,,,,,,,,,,,,,,,, very clean ,crisp work to a high standard :clap: :clap: :clap: :clap: I hope we will be seeing more of this engine build :D
Regards Rob
Dean W:
Bernd, thanks for the comments on the web site.
Rob, I appreciate your nice remarks!
Here are a few more shots:
Con-rod and crankshaft being assembled with high strength sleeve retainer.
Some of the various pins and rods. The smaller ones are 1/16" dia. I made a collet closer for the Atlas
a while back, and it sure came in handy for doing those wee pins.
Ground up a .022" circlip groove cutter to cut a couple of the pins for clips.
Drilling to start a bored hole for the displacer can.
The displacer can and it's cap. The can has a wall of .012".
Here's the displacer can complete
The parts so far.
Thanks for checking it out. Will have some more in a couple of days.
Dean
shoey51:
:jaw: :jaw: just came accros this one :bow: :bow: :bow:
looking forward to further instalments
Graham
madjackghengis:
Looks like you've got a good start on an engine, Dean, looking forward to seeing how it all goes together and works. Those are some fine looking parts you've machined. :thumbup: mad jack
chuck foster:
:jaw: :bugeye: wow :bugeye: :jaw:
you are doing some very fine machining...........i am sure jerry would be very pleased. :thumbup: :clap:
chuck :wave:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version