| Gallery, Projects and General > How do I?? |
| Speeds and Feeds ?. |
| << < (2/4) > >> |
| bright spark:
Titanium, may be, it was in the bottom of an old toolbox I got. The flycutter trimmed it OK, and that had what I think is an HSS bit in it. Thanks for the tip re the Tacho, I have just bought one. This milling is turning out to be an expensive business !. There's a collet chuck, Collets, Milling Vice, tilting vice, new cutters, tacho, clamping kit, step blocks, etc.................. Ken |
| No1_sonuk:
--- Quote from: colin563 on May 11, 2010, 05:32:18 PM ---this is all you need http://cgi.ebay.co.uk/Digital-Laser-Non-Contact-Photo-Tachometer-RPM-Test-LED-/250622053721?cmd=ViewItem&pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item3a5a3d0d59 colin --- End quote --- I couldn't buy it. :( "You either don't have a PayPal account or your PayPal account is not linked to your eBay account." I don't get it. I have a paypal account, and it's linked to my ebay account... I'm gonna try this: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=130359923593&ssPageName=STRK:MEWAX:IT A tad more expensive, but it's dispatched from the UK. |
| bright spark:
I actually got this one, Ebay No 320433266066. They all look approx the same and probably have the same guts, (Like the Seig X2). Paypal occasionally screws up, you can phone them up and ask why its not happening. Ken |
| Dean W:
You're pretty sure that's aluminum, Ken? Does a magnet stick to it? Not trying to be insulting by asking that. I've just never seen al do that to an end mill. Hard to imagine it. Regarding the looks of the cut, it appears that your gibs need attention. It looks like they may be pretty loose. I hope you get it figured out. You sure don't want to be going through tool bits at that rate! Dean |
| No1_sonuk:
The cut might be too deep for that cutter. I know mine complains if I try to munch too much at once. |
| Navigation |
| Message Index |
| Next page |
| Previous page |