| Gallery, Projects and General > How do I?? |
| Using a surface Grinder |
| << < (3/3) |
| Darren:
--- Quote from: Rob.Wilson on April 24, 2010, 09:09:45 AM --- I would as Kvom ,said , grind the mag chuck true , when you do , do it with it turned on . Cheers Rob --- End quote --- Now that's a tip I've not seen elsewhere, turn the chuck on when you grind it ... ta .. :thumbup: That wheels very blue, don't let the missus see that :lol: Kvom, How have you found the repeatability of removing the mag chuck and putting it back on again after you have ground it true? Is it doable? I only ask as I have a J&S grinding vice as well and I may wish to swap and change. Fortunately there's a diamond hiding in this picture that came with the grinder .. :D I was quite impressed how viciously it attacks a grinding wheel if you don't take it easy :lol: |
| Rob.Wilson:
Hi Darren I have the same vice , most times i just stick it to the Mag chuck , when i have removed the chuck , it gose back ok no regrined needed :thumbup: Cheers Rob |
| kvom:
The only time I ground something not held directly on the mag chuck was the angle plates. For that I used a small grinding vise that was held by the mag chuck. |
| Navigation |
| Message Index |
| Previous page |