| Gallery, Projects and General > Project Logs |
| Potty Finger Engine |
| << < (2/9) > >> |
| Divided he ad:
Now I like that!!! :jaw: I'm going to have to have a go with some brass at some time.... All sorts of effects have just been opened up to me :ddb: Cheers Stew :thumbup: Looking forward to your take on one of these.... I've still got 4 to finish! All about half (ish) made have been for best part of 12 months ::) Ralph. |
| sbwhart:
--- Quote from: Divided he ad on April 04, 2010, 07:19:18 PM --- I've still got 4 to finish! All about half (ish) made have been for best part of 12 months ::) Ralph. --- End quote --- :poke: :poke: :poke: :poke: :poke: :poke: Stew |
| sbwhart:
Thanks Guys Doing that flutting worked out better then I expecting, it just takes quite a while to go the circle (45 min) I did it in two cuts:- 2mm rougher and a 0.25 finisher. Got a bit more done this morning. Part off from the bar stock if you tried parting off this thickness in one go you'd end up in trouble, best way is to do it in steps so you keep the groove twice the width of the tool, then for the last bit just adjust the cut so that your bringing the disc to thickness. And her's the first disc stuck in the rim with high strength loctite. Looking good :thumbup: Have fun Stew |
| zeroaxe:
--- Quote from: sbwhart on April 05, 2010, 04:54:27 AM --- Stew --- End quote --- Jsut a quickie about the Loctite. I assume that itis put all around the edge of the hub? And if so, once you put it in place, did you have to wipe off any residual Loctite in all the grooves(or "V"s) ? Looking good there :thumbup: |
| madjackghengis:
Hi Stew, that's a great looking center for the flywheel, I like the way you did the fluting, I'm going to have to try that on an engine for the wife, maybe a finger engine to keep her finger occupied, and out of trouble. Nothing quite like aluminum and brass working together for good looks. Mad Jack :beer: |
| Navigation |
| Message Index |
| Next page |
| Previous page |