Gallery, Projects and General > Project Logs
Ball Turner for 7X12 Lathe
Divided he ad:
Nice work Joe, following a re-design through to see if it works is usually fun... Sometimes not so much ::)
But on this occasion it sounds like it's a winner :nrocks:
Now.... Let's see what you can make with it :thumbup: :dremel:
Ralph.
75Plus:
--- Quote from: 75Plus on April 03, 2010, 09:13:52 PM --- I am unable to find any looseness and, turning some hard stainless, there was chatter. Guess you can tell that I am very happy with the result.
--- End quote ---
That should have read "There was NO chatter" :borg: :borg:
Ralph, I got several ideas from your thread while making the BT and I intend to study your BT Tutorial as I put it to work. It's posts like yours that keep me motivated. Thanks.
Joe
Divided he ad:
No chatter is certainly better :thumbup: the old typo's rearing their heads :lol:
--- Quote ---It's posts like yours that keep me motivated. Thanks.
--- End quote ---
Your posts, my posts and all the others get us all thinking about differing designs and on crazy tangents that just might work! That's the fun of this palce :mmr:
I think it's the forum in general.... I've had my share of weeks off recently, been back on posting a bit more than I was, made a few videos and it's cheered me up no end and I've been in the 'shop the last 3 days :dremel: :)
Didn't come in last night till gone 02:30!! (Not something to do every night mind.)
--- Quote ---I intend to study your BT Tutorial as I put it to work.
--- End quote ---
Good stuff, take what you can from the videos... Then let your imagination run riot :ddb: :thumbup:
Ralph.
Navigation
[0] Message Index
[*] Previous page
Go to full version