Gallery, Projects and General > Project Logs
Steam Engine Wickholders.
Stilldrillin:
On with the 2nd op......
Found I`d parted off all of them to within .004" oal. Not bad for an old `un, with a 6" rule...... :D
Turn locating dia to .003" interference.......
Drill through to .050" short of breakthrough....... Remember, 9 turns tailstock handle.
Not much wall thickness left......
3rd op. Drill 1mm dia breather holes.
All done..... Time for a group shot!
4off, bound for Germany.
2off for America.
2off for Australia.
NO woopsies! :headbang: 4off spare, for as & when.......
Just a bit pleased! :)
David D
CrewCab:
Nice going David :thumbup:
CC
sbwhart:
--- Quote from: Stilldrillin on March 23, 2010, 02:13:19 PM ---
All done..... Time for a group shot!
4off, bound for Germany.
2off for America.
2off for Australia.
--- End quote ---
You should go under the name stilldrillin international, :D
Well done Dave nicely shown :thumbup:
Stew
Bernd:
Nice work. :thumbup:
Quite a world wide clientel there too. :clap:
Bernd
slowcoach:
Nice bit of production work :thumbup: fancy a job at my place :clap:
Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version