Gallery, Projects and General > How do I??

Woodscrew Thread Cutting

<< < (3/3)

75Plus:

--- Quote from: No1_sonuk on March 14, 2010, 09:19:29 PM ---I need to make a part similar to the attached photo.   It needs to go into the end of a 1" wood dowel.

--- End quote ---

I believe you missed it again CC. ::)
Bet not many of the items you use a similar device on is made from a 1" dowel. :med: :med:

Joe

andyf:

--- Quote from: CrewCab on March 15, 2010, 05:31:29 PM ---
Having looked again I can see what you need, the picture reminded me of a wooden screw from a while back, anyway it's one of these I presume



I use a few, long one in the butt and short one in the fore stock


--- End quote ---

Damn :bang: Never thought of that, and I was Range Officer tonight, so could have ferreted round the junkboxes to see if there were any of those still around from the old days of 2-point slings.

Andy

No1_sonuk:
Gentlemen, I draw your attention to the picture in my original post...

It is a "Deben" screw...  Same thing, just grabbed the photo from a different site.
However, I'm not wanting it for sling swivels.  The hole needs to be further from the shoulder.

No1_sonuk:
Update:
The "dowel" is actually a piece of broom handle, and is very hard.

I drilled a 7mm hole in a test piece and ran an M8 machine screw into it.  It held very well.

So, I made the part with an M8 thread and it works fine.

Navigation

[0] Message Index

[*] Previous page