| Gallery, Projects and General > How do I?? |
| Woodscrew Thread Cutting |
| << < (3/3) |
| 75Plus:
--- Quote from: No1_sonuk on March 14, 2010, 09:19:29 PM ---I need to make a part similar to the attached photo. It needs to go into the end of a 1" wood dowel. --- End quote --- I believe you missed it again CC. ::) Bet not many of the items you use a similar device on is made from a 1" dowel. :med: :med: Joe |
| andyf:
--- Quote from: CrewCab on March 15, 2010, 05:31:29 PM --- Having looked again I can see what you need, the picture reminded me of a wooden screw from a while back, anyway it's one of these I presume I use a few, long one in the butt and short one in the fore stock --- End quote --- Damn :bang: Never thought of that, and I was Range Officer tonight, so could have ferreted round the junkboxes to see if there were any of those still around from the old days of 2-point slings. Andy |
| No1_sonuk:
Gentlemen, I draw your attention to the picture in my original post... It is a "Deben" screw... Same thing, just grabbed the photo from a different site. However, I'm not wanting it for sling swivels. The hole needs to be further from the shoulder. |
| No1_sonuk:
Update: The "dowel" is actually a piece of broom handle, and is very hard. I drilled a 7mm hole in a test piece and ran an M8 machine screw into it. It held very well. So, I made the part with an M8 thread and it works fine. |
| Navigation |
| Message Index |
| Previous page |