Gallery, Projects and General > How do I??

How do I make all my Tee nuts the same?

<< < (4/4)

No1_sonuk:

--- Quote from: John Rudd on March 08, 2010, 12:44:49 PM ---they cant be clamped to the mill table because they are too small again....
--- End quote ---
How about clamping them to the rotary table you made them for?  Put a sacrificial packing piece underneath (like card) and push them against a reference bar to get them all the same length.

John Rudd:
Job done now fellas....

I put them all on a piece of threaded bar, lined up in the vice and milled the tops levels...

QED...

That just about wraps up the rotary table job...I'll try and post up a couple of piccies if I can get the camera to play nice( grrrrr...)

Navigation

[0] Message Index

[*] Previous page