| Gallery, Projects and General > How do I?? |
| How do I make all my Tee nuts the same? |
| << < (4/4) |
| No1_sonuk:
--- Quote from: John Rudd on March 08, 2010, 12:44:49 PM ---they cant be clamped to the mill table because they are too small again.... --- End quote --- How about clamping them to the rotary table you made them for? Put a sacrificial packing piece underneath (like card) and push them against a reference bar to get them all the same length. |
| John Rudd:
Job done now fellas.... I put them all on a piece of threaded bar, lined up in the vice and milled the tops levels... QED... That just about wraps up the rotary table job...I'll try and post up a couple of piccies if I can get the camera to play nice( grrrrr...) |
| Navigation |
| Message Index |
| Previous page |