Gallery, Projects and General > Project Logs
snow Tandem
Joe d:
Thanks, Eric.
Rob: Good to hear from you, mate! Don't be such a stranger.
Cheers, Joe
Dean W:
You're doing a mighty fine job, Joe.
Dean
madjackghengis:
Hi Joe, good to see some serious progress on that engine, it's also good to know other people have to adjust the size of their pistons on occasion too, I'd hate to feel alone in that regard. Nice job, keep it up and we'll see a real show stopper. mad jack
Joe d:
Well, been a while... caught one of the many bugs going around, and have been bloody miserable for most of the last couple of weeks. Actually stayed home from work one day (I HATE wasting a day off work being ill.) Anyhow, went in the shop every day, and most days came right back out again, realizing that running machinery was not going to end well. Slowly starting to get back to normal, so have slowly started to make some progress
Got the honking big chunk of flat ali squared up and drilled here and there for the base plate
Then started on the coolant return manifold, turned the "funnels" that go on the top of the vertical pipes
soft soldered in place
and then soft soldered them on to a longish bit of pipe that runs back to the coolant tank that isn't built yet
Lots to do still, but it's getting there!
Cheers, Joe
Bernd:
Looking googs Joe. :thumbup:
Sure are a lot of pieces in that engine.
Bernd
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version