The Shop > Metal Stuff
Slowly casting up parts for a steam twin marine engine
<< < (23/27) > >>
Powder Keg:
Looking great!!! Thanks for the shaper Action Pictures!!! Pretty neat stuff there!!!
Artie:
Yeah Rob, shes a big boat! It will take a reasonable amount of metal and Im going to add multiple rises to feed the shrinkage..

Hi PK, ahhh, the shaper..... it was doing its thing..... and a mate walked past and asked me if I was asleep.... I said "no, just mesmerised......" It can do that to you.

Im using off cuts for the steel bits n bobs and therefore have to 'size' it... lots of good times on the shaper doing this.......it is just soooo easy.... :nrocks: :)
Brass_Machine:
A shaper in action....  :headbang:

That is a big base plate! Did you mention or show the size of the boat yet? I will have to go back and look through the thread.

Eric
Artie:
Hi Brass, yup, right at the beginning......the hull is 7.5 feet long... its a big boat....   :thumbup:
Artie:
The basic layout.... and scissors for scale.....



 :wave:
Navigation
Message Index
Next page
Previous page

Go to full version