The Shop > Finishing
Polishing technique.... well it works!
<< < (10/11) > >>
djh82uk:
Thanks for the offer bogs, although Im afraid I live in South Wales.

Ralph I know what you mean regarding focus i start working on something and then think of something better to make :S

Mostly I want to have a go at IC engines tho.

Tooling wise, for the mill I have a mix of Carbide end mills, slot drills, ball end mills etc and for the lathe I have a mix of carbide tipped, brazed tct & HSS.

Tho have just ordered a load of HSS end mills to try out (they were cheap)
bogstandard:
Not to worry.

I found a place to get it from on ebay, but if you email me with your requirements, I will see what can be done.


John
djh82uk:
Well I don't actually have any plans, I was going to base it on the below engine:

http://www.stirlingengine.co.uk/ks90-blue-low-temperature-stirling-engine-1-p.asp


From which I guestimate it needs an ID of 70mm & a height of 17mm

Thanks

DJH
Divided he ad:

--- Quote ---Tooling wise, for the mill I have a mix of Carbide end mills, slot drills, ball end mills etc and for the lathe I have a mix of carbide tipped, brazed tct & HSS.

Tho have just ordered a load of HSS end mills to try out (they were cheap)
--- End quote ---


With that collection you should have no trouble with steel..... Take it easy and it'll all come together  :thumbup:


Good luck with the Stirling..... I still haven't found the bottle to have a go!!!  :)





Ralph.
kvom:
Today I decided to make a lathe arbor for a polishing mop and start to learn the technique.  The arbor is pretty simple.  Started with a 6" piece of 2" diameter 6061 rod.  Turned one end down to 1" diameter for 1.5" length.  On the other end I drilled and tapped for a length of 1/2-13 threaded rod.  The mops that I have have 1/2" holes, so I put one over the rod, add a 2" diameter washer and a nut from my mill camp kit, and it's ready to go.  I am using this with a collet chuck (for safety), hence the 1" diameter for mounting in a 5C collet.  With the mop about 5" from the collet nose and the nose itself several inches long, I have a pretty good space for keeping the hands clear and also for maneuvering larger parts.

I tried it a bit on some aluminum using the black compound, but I knew I needed to come back in the house and review both the video and the Caswell web page.  I'll be blinging on the beam engine parts first.
Navigation
Message Index
Next page
Previous page

Go to full version