The Shop > Electronics & IC Programing

PIC Project 16f887 - Binary Clock

(1/4) > >>

raynerd:
I`ve been working on this code on and off for the last few weeks. Finally got it running on breadboard a few hours ago thanks to my good friend who helped me point out my errors in the circuit. This may have some machining now as I have a case to build!

Part 1 at least:

raynerd:
Aluminium housing for the binary clock....

raynerd:
A start on the circuit:

AdeV:
Looking good  :thumbup:

Are you planning to hollow out the aluminium to contain the circuit?

raynerd:
Hi, thanks for the interest. I want to make this board on PCB which is my next project - building a UV exposure unit and then I had thought about what you suggested - hollow out the ally back and put the circuit the there.. I doubt I could reduce it small enough to fit into the housing but yes I have thought about it and that would be my aim. For now I would just like to get it running so I`m going to cobble together an ugly circuit to wire the unit up and have it running. The 25 leds are problematic in terms of the mess of wiring without pcb.

Thanks
Chris

Navigation

[0] Message Index

[#] Next page