Gallery, Projects and General > The Design Shop

Poor Man's Keyway Slotter

<< < (4/9) > >>

Rob.Wilson:

--- Quote from: Darren on February 08, 2010, 03:36:09 PM ---Rob, your workshop always looks devoid of clutter  :scratch:

Where are all the bits and bobs  :coffee:

--- End quote ---


 :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol:  i WISH , at the moment it looks like someone has tipped the shop up at one end , i took the photos so no crap/mess would show  :)

Hi Bernd , i would go for it , build the DG shaper , melting ally is not to  hard to do , you dont need nothing to special

Cheers Rob ,,,,,,,,,,,,,,,Darren you went in to the shop hours ago  , were is your slotting tool  :dremel: :coffee:

Darren:
It's coming, it's coming .....

Had a disaster with the mill .....  :doh:
The belt kept stretching, I kept adjusting, removing links..... and then again .... and then it snapped  :doh:
It's a Brammer link belt and it's way to old to hold up.

All ok now, robbed one off the 2nd lathe to get it going again and back on the job  :dremel:

fluxcored:
Thank you all for the great replies. You've given me quite a few tips.

Regards.

tel:
Here's a rough one I made - before I got the shaper.

fluxcored:
Tel, I like yours a lot. Thanks for the piccie.

Navigation

[0] Message Index

[#] Next page

[*] Previous page