| Gallery, Projects and General > How do I?? |
| Bronze brazing? |
| << < (3/3) |
| tel:
I don't think MAPP gas would be up to it - and even if it could do it there would be nothing in hand. Far better to go for O/A from the outset. And, yes - plain rods, warmed and dipped in the container of flux powder as needed. For the process to work properly you need to get the temp up to the point where the surface of the parent metal is almost at the point of becoming molten, then dabble your rod into the hot spot and work yur way around with torch and rod, re-dipping in the flux as needed. Takes a little practise, but quite easy once you get the hang of it. |
| Navigation |
| Message Index |
| Previous page |