The Shop > Electronics & IC Programing

Bad Indicator Lamp?

<< < (4/4)

75Plus:

--- Quote from: dsquire on January 31, 2010, 02:24:37 PM ---
I have never seen steel spot welded to aluminum before. Is this an acceptable practice? With this in mind I am going to retire the cooker and recycle the bits for some other use someday.  :(



Don

--- End quote ---

Don, Sunbeam has been welding steel studs to aluminum pot and skillet bottoms for at least 50 years. We got a Sunbeam electric skillet for a wedding gift in 1960 that had stainless steel studs to hold the legs welded to the aluminum bottom which was attached to the stainless steel skillet to improve heat distribution.

Joe

Navigation

[0] Message Index

[*] Previous page