Gallery, Projects and General > Gallery

some of my accessories.

<< < (2/7) > >>

wheeltapper:
Hi
Yes, they are loosely based on Harold Halls articles in Model Engineers Workshop, the grinding rest is an exact copy, the grinding jig was hacked from steel bar instead of a casting and the  knurling tool looks a bit like the original.

cheers
Roy

xo18thfa:
Roy:  very nice work on the shop accessories.  Thanks for showing us.  I have Mr Hall's book with the grinding table plan.  It is on the "to-do" list.  What is you impression now that you have had some time with it.

Thanks, Bob

wheeltapper:
Hi Bob.
I like it. It's nice to be able to sharpen to a consistent angle.
what it really needs is a half nut on the adjuster, It takes time to wind the slide across.

perhaps a future mod  :)

cheers
Roy

Rob.Wilson:
Hi Roy  :wave:

some very nice tooling you have made there  :thumbup: :clap: :clap: i like the tool sharpening rest  :dremel:


Cheers Rob

xo18thfa:
I was looking closer at the plan last night.  Mr Hall has a mod to the fence, actually the halfnut, to help cut back on all the cross travel.

I have a few 7/8" dia steel balls.  Do you think one would work for the table pivot, rather than the 25mm plastic he specifies?

This table is definitely going to happen in my shop.

Thanks  Bob

Navigation

[0] Message Index

[#] Next page

[*] Previous page