Gallery, Projects and General > Gallery
some of my accessories.
wheeltapper:
Hi
I was talking about countersinks in this thread
http://madmodder.net/index.php?topic=4531.30
saves saying the same thing twice. :)
Roy
Bogstandard:
Roy,
A very nice project you have going there.
It's nice to see how you start off with a basic unit, then add bits n' bobs when either the need arises or you feel like making something.
I have no need for such a unit, as I have all little bits of holding tooling that allow me to do it all on my surface grinder, but I am sure, that if I couldn't go that way, I would be making one of these instead.
Nice ones.
John
wongster:
I don't have such wide angle tool and so thought that the 2 countersinks are machined on the lathe. If I remember correctly, they're 120 degree. I'll go find one. Hope it can be used on my Sherline mill.
Regards,
Wong
wheeltapper:
Thanks for the comments Bogs, praise from Caesar indeed.
Roy
xo18thfa:
--- Quote from: Chuck in E. TN on June 02, 2011, 11:50:20 AM ---xo18thfa,
I know this is an old thread, but would an older mouse ball work for the pivot? It's steel cored and has a rubber jacket. Maybe best of both worlds?
Chuck in E. TN
--- End quote ---
Hi Chuck: I did not build this table, so I can't really answer that. I'd go with the hard plastic as Mr hall specifies.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version