The Shop > Tools
Repairing a Cub Lathe
Rob.Wilson:
--- Quote from: Trion on March 01, 2011, 11:02:24 AM ---Again very nicely done! How did you treat the HSS when bending? Did you bend it first, then heat treat and quench?
--- End quote ---
Hi Trion
Just heat it up and bend it , then i dumped it in water :dremel: ,,, NOT THE CORRECT WAY but it works :ddb:
Rob
DICKEYBIRD:
Yer an inspiration Rob; I'm a'luvin' this thread! :beer:
I noticed in the pic of the finished 2-piece bronze nut that there are 2 allen setscrews and 2 SHCS's. Is this how the backlash is adjusted? The 2 setscrews are adjusted to spread the pieces apart to take out the slack then the SHCS's are locked down to hold it?
Milton
Rob.Wilson:
Thanks for the compliments Lads :beer:
And yes your both spot on :thumbup: :med: :D
Cheers Rob
Rob.Wilson:
Well she is up and running :ddb: :ddb: :ddb: :ddb: job done :) well all bar some paint and a bit fine tuning
Knocked up a bracket to get the phase converter up off the floor and up on the wall :dremel: the wiring still needs running in
I will have to fined a new home for my hydraulic rivet closer :doh:
And i will have to make a splash back for the lathe to :dremel:
Rob
sbwhart:
Very nice bit of Kit Rob looks like you've given that lathe a new life.
Well done that man :clap: :clap: :clap: :clap:
Stew
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version