The Shop > Tools

Repairing a Cub Lathe

<< < (22/31) > >>

Rob.Wilson:
Cheers for lookin in lads  :thumbup:


Hi Stefan ,,,,,,,, i, the Aciera great machine to have in the shop  :)   


Yip any oil will do  :med:  ,,,,,,,,, i just had hydraulic oil to hand ,,,,,,,,,, well it was in the van  :coffee:


Rob

sbwhart:
Great bit of tooling Rob

 :thumbup:

Nothing is trueley scrap you can always do something with it  :whip:

Stew

Rob.Wilson:
Cheers Stew


Mr John Stevenson  has a good use for old drill shanks  :med:


Rob

Rob.Wilson:
Next job  :dremel:


The cross slide nut ,,, milled up a block of bronze , bored and screw cut 8TPI ,,, remembering to make it left handed  ::)



Still a bit of machining to do  :dremel:  ,,,, you can see the wear on the old screw in this shot ,,,, the nut is in  even worse condition  :coffee:



Rob

Gerhard Olivier:
Rob Magic as always

Loving this thread

Gerhard

Navigation

[0] Message Index

[#] Next page

[*] Previous page