| The Shop > Tools |
| Repairing a Cub Lathe |
| << < (22/31) > >> |
| Rob.Wilson:
Cheers for lookin in lads :thumbup: Hi Stefan ,,,,,,,, i, the Aciera great machine to have in the shop :) Yip any oil will do :med: ,,,,,,,,, i just had hydraulic oil to hand ,,,,,,,,,, well it was in the van :coffee: Rob |
| sbwhart:
Great bit of tooling Rob :thumbup: Nothing is trueley scrap you can always do something with it :whip: Stew |
| Rob.Wilson:
Cheers Stew Mr John Stevenson has a good use for old drill shanks :med: Rob |
| Rob.Wilson:
Next job :dremel: The cross slide nut ,,, milled up a block of bronze , bored and screw cut 8TPI ,,, remembering to make it left handed ::) Still a bit of machining to do :dremel: ,,,, you can see the wear on the old screw in this shot ,,,, the nut is in even worse condition :coffee: Rob |
| Gerhard Olivier:
Rob Magic as always Loving this thread Gerhard |
| Navigation |
| Message Index |
| Next page |
| Previous page |