Home Base > Introductions

I'm a newbie too

(1/2) > >>

JimM:
Hi all

Another newbie here introducing himself - found this site from a link on the HMEM forum and have to say you all sound like a very friendly bunch so hoping to take advantage of that and learn lots from you.

I've no real experience of machining (I'm an accountant by trade !), but I bought an old Atlas lathe and an Elliott Juniormill last year but haven't really used them in anger yet. Determined to get my act together this year and actually start making things, hoping to start off with some simple tooling and a basic wobbler or two and get more creative from there.

Cheers

Jim

dsquire:
Jim

Welcome to MadModder. I think that you will find us a friendly and helpful group of guys. If you have any questions, I'm sure that someone here will have an answer or at least an opinion. Since  :worthless: , show us what you are up to and a few pictures of your shop when you get a chance.  :ddb: :ddb:

Cheers  :beer:

Don

Gerhard Olivier:
Welcome Jim

Small tooling is a good place to start - it give satisfaction to make and again every time you use them.   :mmr:

Gerhard

spuddevans:
Hi there Jim :wave: welcome aboard the good ship Madmodder  :borg:


Tim

Bernd:
Welcome to the collective Jim.  :borg:

I'm sure you'll pick up more than what you'll want to know over here.

Regards,
Bernd

Navigation

[0] Message Index

[#] Next page