Gallery, Projects and General > Project Logs

90 degree V twin engine (my own design)

<< < (5/8) > >>

Brass_Machine:
 :jaw:


Looking good so far!

Would love to see some on the bender.

Eric

Darren:
Very, very impressive work  :bow:

gbritnell:
Hi Eric, I'll post a separate thread on the bender.
George

Bernd:
Holly exhust pipes batman  :jaw:

Nice job George. As I was reading this part of the thread I was about to say that I read else were of a guy doing what you were going to do. Then the bulb went on as to where I'd seen this before.  :doh:  :lol:

Hope to see a vid soon of it running. It's got to sound sweet.  :ddb:

Bernd

dsquire:
George

It is a pleasure as usual watching you carve the swarf off of a chunk of metal to reveal what is hiding inside. You seem to have such a delicate touch and know just how far to go to get the maximum effect. A real work of art in my book. I will be looking forward to you thread on bending pipes as that is something I think will draw a lot of interest.  :ddb: :ddb:

Cheers  :beer:

Don

Navigation

[0] Message Index

[#] Next page

[*] Previous page