Gallery, Projects and General > Project Logs

90 degree V twin engine (my own design)

<< < (3/8) > >>

Bernd:
Nice looking engine George.

Can't wait to see and hear it run.

Bernd

Stilldrillin:
Beautiful work George.....  :thumbup:

David D

GArat:
Great poject....well done!!! :clap:
Best regards
Mauro

gbritnell:
Today's update. I took the manifold off and bored the hole for the carb. It's a snug fit but will also have a small set screw in the bottom. I then made up an air cleaner cover and back plate. I didn't have enough room between the inlet tube on the carb and the head on the adjusting screws so I made the backplate a little bigger and drilled out the holes for the screw. I then relieved the back side around the boss and screw holes. The cover was machined and buffed, after which I drilled all the holes. I did it this way so that the buffing wouldn't round over all the holes. I thought that a shiny piece or two would contrast the finishes on the rest of the pieces.
George

gbritnell:
A few more shots.
George

Navigation

[0] Message Index

[#] Next page

[*] Previous page