| Gallery, Projects and General > Gallery |
| Addition to Rose Engine |
| (1/1) |
| old-biker-uk:
This was one of those projects started years ago (like so many others!). With the Rose Engine up and running (if not finished) I dug out the eccentric chuck bits and finished it. Built to the design by J.A.Batchelor in Model Engineer Magazine, May 1991 Mark |
| RDL:
--- Quote from: old-biker-uk on December 28, 2009, 04:03:05 PM ---This was one of those projects started years ago (like so many others!). With the Rose Engine up and running (if not finished) I dug out the eccentric chuck bits and finished it. ... Built to the design by J.A.Batchelor in Model Engineer Magazine, May 1991 Mark --- End quote --- This project and your work interests me. Is it possible to see more close up pictures and drawings? Raymond |
| old-biker-uk:
Raymond - Check your PMs Some more pics of the chuck: The backplate was welded up from mild steel, the slide hacked out of hot rolled MS with my trusty angle grinder then scraped flat. The original design had a 5/16" x 20 screw but I modified that to 5/16" x 40 to give a finer adjustment. Basically a good exercise in fitting & turning.... I made it for ornamental turning but could also be used for turning eccentrics for model engines etc. (wouldn't want to run it too fast though!) Here's a couple of turned bits, boxwood, about 2" high. Mark |
| Navigation |
| Message Index |