| Gallery, Projects and General > Project Logs |
| Cone Centres |
| << < (2/7) > >> |
| Bernd:
Rob, Just learned something new. I didn't know bearings like you show in the first picture exsisted. By angular I was thinking the kind use on automobile axels. Thanks, Bernd |
| Darren:
I believe you're thinking of taper bearings Bernd ... |
| Rob.Wilson:
Hi Bernd You could use a tapper roller bearing ,,its just that they take up allot of room (ok for large cone centre )and you would have to provide away of ajusting them up,The angular contact bearing is the correct bearing but as you see in the photo the plain radial bearing dose offer some angular contact ,,there allot cheaper too a couple of £ $ each Tapper roller bearing Regards Rob |
| Rob.Wilson:
Sorry Darren i did not see you post :doh: Regards Rob |
| Darren:
Tis OK, yours has nice pictures :clap: |
| Navigation |
| Message Index |
| Next page |
| Previous page |