The Craftmans Shop > Model Engineering

Miniature twin launch engine

(1/3) > >>

gbritnell:
Gentlemen, this is a model I made for the Sherline contest quite a few years back. I took the drawings for the Stuart Twin Launch and scaled them down. Most of the bolts are 1x.25 mm. That's an American quarter in front of it.
George

tel:
Wow. however do those Americans get those 8" dia Quarters in their pockets?

That's a seriously nice bit of work George.

chuck foster:
 :jaw: :bugeye: :jaw: :bugeye: :jaw: :bugeye: :jaw:  :thumbup: :thumbup:

chuck  :wave:

NickG:
That is a beauty! Very nice work George.

Nick

Brass_Machine:

--- Quote from: tel on December 21, 2009, 08:45:13 PM ---Wow. however do those Americans get those 8" dia Quarters in their pockets?

That's a seriously nice bit of work George.

--- End quote ---

I was wondering if I used the the same quarter as him!

Amazing  :bow:

Navigation

[0] Message Index

[#] Next page