The Craftmans Shop > Model Engineering
Miniature twin launch engine
gbritnell:
Gentlemen, this is a model I made for the Sherline contest quite a few years back. I took the drawings for the Stuart Twin Launch and scaled them down. Most of the bolts are 1x.25 mm. That's an American quarter in front of it.
George
tel:
Wow. however do those Americans get those 8" dia Quarters in their pockets?
That's a seriously nice bit of work George.
chuck foster:
:jaw: :bugeye: :jaw: :bugeye: :jaw: :bugeye: :jaw: :thumbup: :thumbup:
chuck :wave:
NickG:
That is a beauty! Very nice work George.
Nick
Brass_Machine:
--- Quote from: tel on December 21, 2009, 08:45:13 PM ---Wow. however do those Americans get those 8" dia Quarters in their pockets?
That's a seriously nice bit of work George.
--- End quote ---
I was wondering if I used the the same quarter as him!
Amazing :bow:
Navigation
[0] Message Index
[#] Next page
Go to full version