Gallery, Projects and General > Gallery
Brass torches....
Brass_Machine:
Good job Wong!
Eric
wongster:
Thanks Eric. I've gotten lots of help from folks in this forum.
Regards,
Wong
Rob.Wilson:
--- Quote from: wongster on July 01, 2010, 07:15:42 PM ---Thanks Rob. Learn a lot from this little project; boring, threading, and attempted knurling. Hope the next piece will be better.
Regards,
Wong
--- End quote ---
Hi Wong
Your off to a good start there , the more you do the easer things will come ,, so whats the next project :poke: :D
Cheers Rob
wongster:
Hi Rob,
A few more brass torches (hopefully one with the acrylic as shown on John Somers' site - nice.... ) before I trying making extra tool holders for my A2ZCNC QCTP, Toolmakers' Clamps, Mini Surface Gauge, Adjustable Angle Plate.... greedy huh? :) At least one engine that is not too difficult for beginners. The kids will love it.
Regards,
Wong
Brass_Machine:
--- Quote from: wongster on July 02, 2010, 07:50:13 PM ---Hi Rob,
A few more brass torches (hopefully one with the acrylic as shown on John Somers' site - nice.... ) before I trying making extra tool holders for my A2ZCNC QCTP, Toolmakers' Clamps, Mini Surface Gauge, Adjustable Angle Plate.... greedy huh? :) At least one engine that is not too difficult for beginners. The kids will love it.
Regards,
Wong
--- End quote ---
I wouldn't say greedy... sounds like you have :proj: !!!
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version