The Shop > Our Shop

gingerneer's shed

<< < (3/3)

bramley51:
Geez,Gingerneer,you've got an amazing amount of stuff in there.Very well organized too.
And I'm grumbling my 20x10' is too small :D.

raynerd:
Hey Mate, nice organised little shop you got there. Just need a belt drive conversion on that chester conquest...  :proj:

Chris

gingerneer:
bramley51 I have just got to keep it tidy, i have been out tonight and the bench is starting to get covered again...... I do also shared it with my farther, most of what is under the benchs is his tools and "stuff". The boxes have made a big diffrence through.

craynerd Its on the long list of projects, but some where down the bottow at the moment, i have only got it back into working order after something went on the circut board. I have already replaced the platic gear with a brass replacement i machined. I do find that i get a lot of chatter when milling, i think it can do with a total strip down and clean/adjustment, possible replace the bearings in the spindle. Then theres the plan to fit DRO on it.......
What mods (other than the belt drive) have you done to yours?

Gingerneer 

JimM:
Nice looking shop you've got there.

Where did you get the clear boxes from, the thinner ones look a really useful size

Cheers
Jim

Navigation

[0] Message Index

[*] Previous page