Gallery, Projects and General > Project Logs
Three Cylinder Radial Engine
Stilldrillin:
Nicely done and shown Stew...... As usual! :thumbup:
And a Happy New Year to you and yours! :wave:
David D
NickG:
Wow, :bugeye:
You did those con rods so well I've just thought of a genius nick name for you - Rod Stewart! :lol: :doh: never mind!
Seriously, they are really impressive, everything seems churned from the solid on this! Looking good.
Nick
Powder Keg:
Nice job on the rods Stewart :lol:
sbwhart:
Made a start on the pistons over the last couple of days. The first thing I did was to hone the cylinders sp that I would have a final size to work with, I used a flexie hone with plenty of oil, I didn't go over board with the honing just a quick lick up and down for about 10 seconds, but it was enough to produce a nice smooth bore.
Then used this new toy to give the cylinders a good clean, its a lidle ultrasonic cleaner on offer for £20:- Great for cleaning glasses and false teeth, wanted to try it out on Mother in-laws teeth, but the miserable old bugger wouldn't let me.
Then I carefully measure the bores they were all within 0.02 mm and kept a not with each one of their size.
The turned down a chunk a window sash weight and drilled and bored the ID.
Then I wanted to try out my home made tool post grinder to get a nice finish on the OD of the cylinder, it took me a good bit of time and a lot of 13 amp fuzes (don't ask :zap:) to wire up the new toggle switch I'd bought for it.
But it worked a treat got a nice finish on the cast iron and a nice fit.
This is two ground up and just sitting nicely in the bore, the third is still on the bar waiting to be parted off:- thats a job for another day
Have fun
Stew
NickG:
Stew,
Looking great, I bet with that flexi hone and grinder you have got an amazing fit there. Very nice. That ultrasonic cleaner is a bit posh too, did it work well?
Nick
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version