| Gallery, Projects and General > Project Logs |
| Three Cylinder Radial Engine |
| << < (2/32) > >> |
| Russel:
I really like radial engines...looking forward to your build! Russ |
| Brass_Machine:
Radial engine fan meself. Watching this one! Eric |
| Stilldrillin:
That looks a very interesting project Stew..... :thumbup: Good luck! I`m watching, quietly..... :wave: David D |
| sbwhart:
Well chaps here's some more. Finished off the bore and then brought everything to finished size, Home made boring bar worked fine, although I had to trim a bit more off it to keep it clear of the job. Now your going to love this bit. Keeping the job in the chuck the whole lot was transfered to :----------------------------- wait for it wait for it:----------------------------------------- The indexer. First job with a wobbler find the edges of the job:- zero the X on centre line and zero the Y on the front edge. With the fly cutter I then made the round bar into an hexagon, this is where the table stops paid for them self with the stops set I had no worries about running into the chuck. Forget to take a pic of the fly cutting but you've seen that before. Move the Y to where the cylinders will be mounted and zero the dro again from know on all features will be from the centre line of this hole. Centre drill then roughing drill to get the meat out. Note use of support Jack And then with the boring head rough out all the to within 0.5 mm Thats it for today. :beer: Have fun Stew |
| John Hill:
Nice work! :thumbup: [thinks] I really, really need to buy more toys! [/thinks] |
| Navigation |
| Message Index |
| Next page |
| Previous page |