Gallery, Projects and General > Project Logs

Knurling tool

<< < (4/4)

Shepherduke:
  Lovely piece of work geroli.  Do you have a drawing for this (or any other)
  Die Holder?  It looks too good to use!  Shepherduke

Gerhard Olivier:
Thanks for comments chaps

I suppose it is lazy to not want to change the cutters over but now I know I will use the most appropriae knurl rather than the one that is in the knurling tool. :med:



Sheperduke The die holder build is on here somewhere   
http://madmodder.net/index.php?topic=2066.0

And Russel made one as well  http://madmodder.net/index.php?topic=2187.0
If you need a COC will do but it is really easy to make.  Mine fits over the tailstock ram - but most uses a steel bar held in the tailstock.

Gerhard

Shepherduke:
  Thanks for that geroli.  Due to the Knurling tool and Tailstock t&d holders
  projects of yours, I am inspired to start making a few bits and pieces on     my   new mini lathe ( after my hip operation next Friday, and six weeks  recouperation! ).
  I have been searching for a book which deals with  similar  projects, but my local library reports that all such books have been "mislaid".  If you or anyone else reading this post can recommend such a book, I would be very grateful.  Shepherduke. 

Bernd:
This guy is Canadian based. Published the 3 Bedside Readers. Might be of interest. Guy Lautard's Beside Readers

Bernd

Divided he ad:
Gerhard....


Very nice tool build  :thumbup:

Really like the use of the ball cutter..... And the knurl on the radius... inspiring! never thought of that one, top marks  :bow:


You know I'm going to have to try and copy that now  :dremel:



I don't do too much knurling, find it difficult at times, think I may need to buy some new/sharper knurls..... I think stainless steel and inexperience killed mine a while ago! ::)



Again, very good topic  :thumbup:



This tuit list is getting massive!






Ralph.

Navigation

[0] Message Index

[*] Previous page