Gallery, Projects and General > Project Logs

started a new project

<< < (13/15) > >>

Darren:
It's looking great and coming along nicely  :nrocks:

Is the rocker arm cast, if so where did it come from  :scratch:

Rob.Wilson:
Hi Chuck

Great job ,i like the way you made the main bearing  :clap: :clap: :clap: ,,cant wait to see it running

Regards Rob

Bernd:
Lookin' good Chuck.

And about that twist, not bad. Almost looks like the original.  :lol:

Nice fabrication job on the whole engine by the way. :thumbup:

Bernd

chuck foster:
darren the rocker arm is fabricated, so far the only part's that will be castings are the flywheel's the rest will be fabricated.
fabricating takes more time but so far i'm enjoying the whole project.  :D

next up is the cam shaft bearings and the original looks like this



here are the part's used to fabricate one bearing (i need two bearings for this engine)



the bearing center gets two cut out's were the bolt posts go



next picture show's a complete bearing assembly ready for silver soldering



silver soldered and ready for cleaning





cleaned and installed on the engine





well now it's off to look at some full size gas engine's and one might just follow me home  :ddb: :ddb:

chuck  :wave:

 

Bernd:
Nice Chuck,

They almost look like castings. Can't wait to see this engine running.

Bernd

Navigation

[0] Message Index

[#] Next page

[*] Previous page