Gallery, Projects and General > Project Logs
4" Vertex Rotary Table CNC conversion
<< < (13/16) > >>
kwackers:
I don't deliberately design my pcbs to be quick to etch, being tight I like to remove as little copper as possible... :lol:
raynerd:
No Kwackers, your more than right! I`m not sucking up here but your board is perfect, less etching and a quicker time!! I must admit though, for someone etching for the first time or using the print transfer, this other is a good one!
johnstij:
Hi all.
I've been following Kwackers  build on CNCzone from the beginning with great interest, and after seeing Craynerd's build on here I took the plunge to build one.I've never etched a PCB before but using the OHP film method I produced a very good board at the first attempt ( just lucky?? I etched a second PCB  to just see, & this one was as good) The rotary table had allready been fitted with a stepper motor for use with MACH 3 on my CNC emco mill. But this controller is so use full as a stand alone divider.
 Thanks to Steve & Chris for sharing this great device.

note: keypad is not fixed down yet
John Stevenson:
John, Which driver board is that please ?

John S.
johnstij:
John s.


It was  off ebay from Hong Kong (no surprise there !!)

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=250990148810
Navigation
Message Index
Next page
Previous page

Go to full version